FindImagePos

[conjure]

Hi. I want to scan the image i attached and move the mouse at the bottom of the red bar.
I tried

Code: Select all

ScreenCapture>1630,920,1656,1069,%TEMP_DIR%\screenrect2.bmp
FindImagePos>Z:\%ppc%\down.bmp,%TEMP_DIR%\screenrect2.bmp,0,1,XArr,YArr,NumFound
If>NumFound>0
MouseMove>{%XArr_0%+1630},{%YArr_0%+920}
mdl>%YArr_0%
endif

but the mouse goes only on the top of the bar.
Ps. the bar is always different size
(the down.bmp is one red pixel)

Any ideas on how to do it?
Thank you

[Marcus Tettmar]

Change the return_offset value to 6 (middle bottom). If you want it below the bar, then you can also add a value to the y offset position.

[conjure]

I m sorry Marcus i didn't understand.Can you post an example?

[Marcus Tettmar]

Please see the help file:

return_offset is used to determine which coordinates should be returned and can be one of the following:

0
Top left position of located image within bitmap_to_scan. In other words X, Y is the top left corner of needle_bitmap within haystack
1
Center: X,Y will be set to the center of the located image within the main haystack image.
2
Top right
3
Bottom left
4
Bottom right
5
Middle top
6
Middle bottom
7
Middle left
8
Middle right